Search results for " FDM"
showing 5 items of 5 documents
A numerical solution that determines the temperature field inside phase change materials: application in buildings
2013
The use of novel building materials that contain active thermal components would be a major advancement in achieving significant heating and cooling energy savings. In the last 40 years, Phase Change Materials or PCMs have been tested as thermal mass components in buildings, and most studies have found that PCMs enhance the building energy performance. The use of PCMs as an energy storage device is due to their relatively high fusion latent heat; during the melting and/or solidification phase, a PCM is capable of storing or releasing a large amount of energy. PCMs in a wall layer store solar energy during the warmer hours of the day and release it during the night, thereby decreasing and sh…
A Finite Difference Model of a PV-PCM System
2012
Abstract The performances of a photovoltaic panel (PV) are defined according to the “peak power” that identifies the maximum electric power supplied by the panel when it receives an insolation of 1 kW/m2 and the temperature of the cell is maintained at 25 °C. These conditions are only nominal since the solar radiation has a variable intensity and also the panel is subjected to thermal excursions; due to these reasons the real power efficiency of the panel is considerably lower than that obtainable in the nominal conditions. The study focused on assessing a method to reduce the peak temperatures of PV systems using Phase Change Materials (PCM). To this aim it was created a numerical model ca…
Green Composites Based on Hedysarum coronarium with Outstanding FDM Printability and Mechanical Performance
2022
The addition of natural scraps to biodegradable polymers has gained particular interest in recent years, allowing reducing environmental pollution related to traditional plastic. In this work, new composites were fabricated by adding 10% or 20% of Hedysarum coronarium (HC) flour to Poly (lactic acid) (PLA). The two formulations were first produced by twin screw extrusion and the obtained filaments were then employed for the fabrication of composites, either for compression molding (CM) or by fused deposition modeling (FDM), and characterized from a morphological and mechanical point of view. Through FDM it was possible to achieve dense structures with good wettability of the filler that, on…
Hedysarum coronarium-Based Green Composites Prepared by Compression Molding and Fused Deposition Modeling
2022
In this work, an innovative green composite was produced by adding Hedysarum coronarium (HC) flour to a starch-based biodegradable polymer (Mater-Bi®, MB). The flour was obtained by grinding together stems, leaves and flowers and subsequently sieving it, selecting a fraction from 75 μm to 300 μm. Four formulations have been produced by compression molding (CM) and fused deposition modeling (FDM) by adding 5%, 10%, 15% and 20% of HC to MB. The influence of filler content on the processability was tested, and rheological, morphological and mechanical properties of composites were also assessed. Through CM, it was possible to obtain easily homogeneous samples with all filler amounts.…
Green Composites Based on Mater-Bi® and Solanum lycopersicum Plant Waste for 3D Printing Applications
2023
3D printability of green composites is currently experiencing a boost in importance and interest, envisaging a way to valorise agricultural waste, in order to obtain affordable fillers for the preparation of biodegradable polymer-based composites with reduced cost and environmental impact, without undermining processability and mechanical performance. In this work, an innovative green composite was prepared by combining a starch-based biodegradable polymer (Mater-Bi®, MB) and a filler obtained from the lignocellulosic waste coming from Solanum lycopersicum (i.e., tomato plant) harvesting. Different processing parameters and different filler amounts were investigated, and the obtained sample…